PD1NL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PD1NL-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1772624637	539 Count	280 Count
1772622870	538 Count	280 Count
1772621067	537 Count	280 Count
1772619264	536 Count	279 Count
1772617461	535 Count	269 Count
1772615658	534 Count	269 Count
1772613855	533 Count	269 Count
1772612052	532 Count	269 Count
1772610249	531 Count	269 Count
1772608446	530 Count	269 Count
1772606643	529 Count	269 Count
1772604840	528 Count	269 Count
1772603037	527 Count	269 Count
1772601270	526 Count	269 Count
1772599467	525 Count	269 Count
1772597663	524 Count	269 Count
1772596293	499 Count	233 Count
1772596293	506 Count	251 Count
1772596293	521 Count	269 Count
1772596293	500 Count	243 Count
1772596293	505 Count	243 Count
1772596293	511 Count	269 Count
1772596293	520 Count	269 Count
1772596293	509 Count	269 Count
1772596293	522 Count	269 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)