OZ7DIH-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OZ7DIH-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Eff1h*
1761534501	12.48 Volt	100 Pcnt
1761533298	12.48 Volt	100 Pcnt
1761532409	12.48 Volt	100 Pcnt
1761532107	12.48 Volt	100 Pcnt
1761528499	12.48 Volt	0 Pcnt
1761527920	12.48 Volt	0 Pcnt
1761526771	12.48 Volt	50 Pcnt
1761526412	12.48 Volt	50 Pcnt
1761525830	12.48 Volt	50 Pcnt
1761525548	12.48 Volt	50 Pcnt
1761525264	12.48 Volt	75 Pcnt
1761524637	12.48 Volt	100 Pcnt
1761524017	12.48 Volt	100 Pcnt
1761523692	12.48 Volt	100 Pcnt
1761523113	12.48 Volt	100 Pcnt
1761522806	12.48 Volt	100 Pcnt
1761521893	12.48 Volt	100 Pcnt
1761521662	12.48 Volt	100 Pcnt
1761521290	12.48 Volt	87 Pcnt
1761515284	12.48 Volt	77 Pcnt
1761506873	12.48 Volt	100 Pcnt
1761501466	12.48 Volt	90 Pcnt
1761501166	12.48 Volt	90 Pcnt
1761500865	12.48 Volt	90 Pcnt
1761497863	12.48 Volt	90 Pcnt

*Used Equation Coefficients:

Vin: 0, 0.079, 0

Rx1h: 0, 10, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)