IK6FUE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IK6FUE-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	T Ambi*
1765569575	12.75 Volt	7.8 °C
1765569277	12.75 Volt	7.8 °C
1765569275	12.75 Volt	7.8 °C
1765568975	12.75 Volt	7.8 °C
1765568677	12.75 Volt	7.8 °C
1765568675	12.75 Volt	7.8 °C
1765568375	12.75 Volt	7.8 °C
1765568077	12.75 Volt	7.8 °C
1765568075	12.75 Volt	7.8 °C
1765567775	12.75 Volt	7.8 °C
1765567477	12.75 Volt	7.8 °C
1765567475	12.75 Volt	7.8 °C
1765567175	12.75 Volt	7.8 °C
1765566879	12.68 Volt	7.8 °C
1765566875	12.68 Volt	7.8 °C
1765566575	12.75 Volt	7.8 °C
1765566277	12.75 Volt	7.8 °C
1765566275	12.75 Volt	7.8 °C
1765565975	12.75 Volt	7.8 °C
1765565677	12.75 Volt	7.8 °C
1765565675	12.75 Volt	7.8 °C
1765565375	12.75 Volt	7.8 °C
1765565077	12.75 Volt	7.8 °C
1765565075	12.75 Volt	7.8 °C
1765564775	12.75 Volt	7.8 °C

*Used Equation Coefficients:

Vin: 0, 0.075, 0

V Pane: 0, 0.075, 0

A Pane: 0, 0.1953, -24.9984

T Ambi: 0, 0.9, -129

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)