OE6XDG-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OE6XDG-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp.in*	Temp.out*
1757468596	0 C deg	10.8 C deg
1757466796	0 C deg	10.8 C deg
1757464996	0 C deg	10.9 C deg
1757463196	0 C deg	10.9 C deg
1757461396	0 C deg	10.9 C deg
1757459596	0 C deg	11 C deg
1757457796	0 C deg	11 C deg
1757455996	0 C deg	11.1 C deg
1757454196	0 C deg	11.1 C deg
1757452396	0 C deg	11.2 C deg
1757450596	0 C deg	11.2 C deg
1757448796	0 C deg	11.4 C deg
1757446996	0 C deg	11.4 C deg
1757445196	0 C deg	11.6 C deg
1757443396	0 C deg	11.8 C deg
1757441596	0 C deg	11.9 C deg
1757439796	0 C deg	12 C deg
1757437996	0 C deg	12.1 C deg
1757436196	0 C deg	12.2 C deg
1757434396	0 C deg	12.2 C deg
1757432596	0 C deg	12.2 C deg
1757430796	0 C deg	12.1 C deg
1757428996	0 C deg	12.1 C deg
1757427196	0 C deg	12.1 C deg
1757425396	0 C deg	12 C deg

*Used Equation Coefficients:

Press: 0, 1, 0

Temp.in: 0, 1, 0

Hum: 0, 1, 0

QNH: 0, 1, 0

Temp.out: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)