MAGMTN Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MAGMTN. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Battery*	Temp*
1789950950	13.31 Volts	111 deg.F
1789949760	13.94 Volts	112 deg.F
1789948555	14.59 Volts	115 deg.F
1789947308	13.94 Volts	115 deg.F
1789946175	13.98 Volts	114 deg.F
1789945140	13.96 Volts	116 deg.F
1789944093	13.96 Volts	115 deg.F
1789943000	13.96 Volts	114 deg.F
1789941880	13.96 Volts	114 deg.F
1789940658	13.94 Volts	115 deg.F
1789939570	13.94 Volts	112 deg.F
1789938421	13.96 Volts	111 deg.F
1789937285	13.94 Volts	111 deg.F
1789936272	13.96 Volts	110 deg.F
1789935170	13.94 Volts	110 deg.F
1789933982	13.96 Volts	109 deg.F
1789932947	13.94 Volts	111 deg.F
1789931807	13.96 Volts	111 deg.F
1789930593	13.96 Volts	111 deg.F
1789929495	13.96 Volts	112 deg.F
1789928277	13.94 Volts	111 deg.F
1789927142	13.96 Volts	111 deg.F
1789926095	13.96 Volts	112 deg.F
1789924915	13.94 Volts	111 deg.F
1789923880	13.96 Volts	110 deg.F

*Used Equation Coefficients:

Battery: 0, 1, 0

Temp: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 0, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)