KF6VAN-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object KF6VAN-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1789971943	142	46	32	23	120
1789970145	142	46	32	23	121
1789968344	142	45	31	24	121
1789966543	142	45	31	22	121
1789964743	141	45	31	22	121
1789962943	143	46	32	23	120
1789961143	141	45	31	23	121
1789959342	143	44	31	23	121
1789957543	142	45	31	24	120
1789955742	142	42	29	23	120
1789953942	142	43	30	23	121
1789952142	138	41	30	22	120
1789950342	143	41	30	23	120
1789948542	142	40	28	22	119
1789946742	143	38	29	22	119
1789944942	142	40	29	21	119
1789943142	143	39	29	21	119
1789941342	142	39	28	22	119
1789939542	142	39	28	22	119
1789937742	142	40	28	22	120
1789935942	142	40	29	22	120
1789934142	142	43	30	23	120
1789932342	142	43	31	22	121
1789930542	142	45	31	23	121
1789928742	142	45	32	23	120

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)