OE6LME-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OE6LME-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp.in*	Temp.out*
1773083361	0 C deg	22.2 C deg
1773079740	0 C deg	21.6 C deg
1773039095	0 C deg	21.2 C deg
1772998718	0 C deg	23.5 C deg
1772996911	0 C deg	23.4 C deg
1772995092	0 C deg	23.3 C deg
1772991458	0 C deg	23.2 C deg
1772989642	0 C deg	23.3 C deg
1772987829	0 C deg	23.4 C deg
1772986021	0 C deg	23.4 C deg
1772982385	0 C deg	23.2 C deg
1772975125	0 C deg	22.8 C deg
1772973306	0 C deg	22.7 C deg
1772971490	0 C deg	22.6 C deg
1772969685	0 C deg	22.4 C deg
1772967862	0 C deg	22.2 C deg
1772966045	0 C deg	22.2 C deg
1772964236	0 C deg	22 C deg
1772955158	0 C deg	21.1 C deg
1772915266	0 C deg	23.6 C deg
1772913451	0 C deg	23.5 C deg
1772911637	0 C deg	23.5 C deg
1772908010	0 C deg	23.4 C deg
1772904381	0 C deg	23.3 C deg
1772902559	0 C deg	23.1 C deg

*Used Equation Coefficients:

Press: 0, 1, 0

Temp.in: 0, 1, 0

Hum: 0, 1, 0

QNH: 0, 1, 0

Temp.out: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)