SP2WH-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2WH-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1761553081	377 Count	588 Count	335 Count
1761549479	361 Count	563 Count	321 Count
1761545879	350 Count	544 Count	312 Count
1761542277	340 Count	525 Count	304 Count
1761540476	335 Count	518 Count	300 Count
1761538676	330 Count	511 Count	296 Count
1761536875	311 Count	476 Count	278 Count
1761535075	295 Count	455 Count	263 Count
1761533274	278 Count	431 Count	247 Count
1761531473	263 Count	413 Count	233 Count
1761529673	243 Count	388 Count	214 Count
1761527872	223 Count	361 Count	195 Count
1761526071	215 Count	343 Count	188 Count
1761524271	203 Count	325 Count	177 Count
1761522470	187 Count	300 Count	162 Count
1761520670	183 Count	290 Count	159 Count
1761518869	177 Count	281 Count	154 Count
1761517068	168 Count	270 Count	146 Count
1761515268	163 Count	261 Count	142 Count
1761513467	154 Count	245 Count	134 Count
1761511667	149 Count	234 Count	130 Count
1761509866	145 Count	228 Count	127 Count
1761508065	141 Count	221 Count	124 Count
1761506265	132 Count	210 Count	116 Count
1761504464	128 Count	203 Count	113 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)