4L0VE-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 4L0VE-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Temp*
1788358281	12.3 Volt	25 C
1788357981	12.23 Volt	26.5 C
1788357681	12.3 Volt	28.5 C
1788357381	12.3 Volt	31 C
1788357081	12.3 Volt	32 C
1788356781	12.3 Volt	33.5 C
1788356481	12.23 Volt	34 C
1788356181	12.3 Volt	34.5 C
1788355881	12.23 Volt	35.5 C
1788355581	12.23 Volt	36.5 C
1788355281	12.23 Volt	37 C
1788354981	12.23 Volt	37.5 C
1788354681	12.23 Volt	37 C
1788354381	12.23 Volt	37 C
1788354081	12.23 Volt	37 C
1788353781	12.23 Volt	37 C
1788353481	12.23 Volt	37 C
1788353181	12.23 Volt	37.5 C
1788352885	12.23 Volt	37.5 C
1788352581	12.23 Volt	37.5 C
1788352281	12.23 Volt	37 C
1788351981	12.23 Volt	36.5 C
1788351681	12.23 Volt	36.5 C
1788351381	12.23 Volt	37 C
1788351081	12.23 Volt	37 C

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Temp: 0, 0.5, -64

Value3: 0, 0, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)