EA4ENG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4ENG-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1757271596	581 Count	776 Count	261 Count
1757270693	579 Count	775 Count	260 Count
1757269789	576 Count	773 Count	258 Count
1757268885	573 Count	771 Count	256 Count
1757268067	570 Count	769 Count	254 Count
1757267164	567 Count	767 Count	252 Count
1757266260	564 Count	765 Count	250 Count
1757265356	560 Count	762 Count	247 Count
1757264452	557 Count	760 Count	245 Count
1757262645	550 Count	755 Count	240 Count
1757261741	546 Count	752 Count	237 Count
1757259934	540 Count	748 Count	233 Count
1757259030	537 Count	746 Count	231 Count
1757258126	533 Count	743 Count	228 Count
1757257222	530 Count	741 Count	226 Count
1757255414	524 Count	737 Count	222 Count
1757253607	518 Count	733 Count	218 Count
1757252703	515 Count	731 Count	216 Count
1757251799	511 Count	728 Count	213 Count
1757250895	508 Count	726 Count	211 Count
1757249992	504 Count	723 Count	208 Count
1757249088	501 Count	721 Count	206 Count
1757248184	497 Count	718 Count	203 Count
1757247280	494 Count	716 Count	201 Count
1757245568	489 Count	713 Count	198 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)