YO8SDE-8 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object YO8SDE-8. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Eff1h*
1789954904	9.45 Volt	100 Pcnt
1789954604	9.45 Volt	100 Pcnt
1789954304	9.45 Volt	100 Pcnt
1789954004	9.45 Volt	100 Pcnt
1789953704	9.45 Volt	100 Pcnt
1789953404	9.45 Volt	100 Pcnt
1789953133	9.45 Volt	100 Pcnt
1789952804	9.45 Volt	100 Pcnt
1789952504	9.45 Volt	100 Pcnt
1789952204	9.45 Volt	100 Pcnt
1789951904	9.45 Volt	100 Pcnt
1789951604	9.45 Volt	100 Pcnt
1789951304	9.45 Volt	100 Pcnt
1789951004	9.45 Volt	100 Pcnt
1789950704	9.45 Volt	100 Pcnt
1789950404	9.45 Volt	100 Pcnt
1789950104	9.45 Volt	100 Pcnt
1789949804	9.45 Volt	100 Pcnt
1789949504	9.45 Volt	100 Pcnt
1789949204	9.45 Volt	100 Pcnt
1789948904	9.45 Volt	100 Pcnt
1789948604	9.45 Volt	100 Pcnt
1789948304	9.45 Volt	100 Pcnt
1789948004	9.45 Volt	100 Pcnt
1789947708	9.45 Volt	100 Pcnt

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Rx1h: 0, 10, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)