OD5RI-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OD5RI-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Eff1h*
1781382662	13.5 Volt	11 Pcnt
1781382363	13.5 Volt	15 Pcnt
1781382362	13.5 Volt	15 Pcnt
1781382062	13.58 Volt	21 Pcnt
1781381765	13.5 Volt	11 Pcnt
1781381762	13.5 Volt	11 Pcnt
1781381462	13.5 Volt	0 Pcnt
1781381169	13.43 Volt	100 Pcnt
1781381162	13.43 Volt	100 Pcnt
1781380862	13.5 Volt	100 Pcnt
1781380564	13.5 Volt	100 Pcnt
1781380562	13.5 Volt	100 Pcnt
1781380262	13.43 Volt	0 Pcnt
1781379962	13.5 Volt	0 Pcnt
1781379662	13.43 Volt	0 Pcnt
1781379371	13.5 Volt	0 Pcnt
1781379362	13.5 Volt	0 Pcnt
1781379062	13.5 Volt	0 Pcnt
1781378762	13.5 Volt	0 Pcnt
1781378762	13.5 Volt	0 Pcnt
1781378462	13.43 Volt	0 Pcnt
1781378163	13.43 Volt	0 Pcnt
1781378162	13.43 Volt	0 Pcnt
1781377862	13.5 Volt	0 Pcnt
1781377565	13.43 Volt	0 Pcnt

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Rx1h: 0, 10, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)