DK2BE Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DK2BE. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp*	Humi*
1762541059	22.1 deg C	59.1 %
1762536556	21.5 deg C	60.7 %
1762535659	21.6 deg C	60.7 %
1762532967	21.5 deg C	60.7 %
1762530249	21.1 deg C	60.6 %
1762529353	21 deg C	60.5 %
1762528458	20.9 deg C	60.2 %
1762523055	20.9 deg C	59.5 %
1762522167	20.8 deg C	59.2 %
1762517658	21 deg C	58.5 %
1762515853	21.1 deg C	58.3 %
1762514971	21.1 deg C	58.3 %
1762514054	21 deg C	58.5 %
1762513158	21 deg C	58.9 %
1762511348	20.6 deg C	59.2 %
1762510445	20.5 deg C	59.2 %
1762509541	20.5 deg C	59.5 %
1762508646	20.5 deg C	59.2 %
1762507748	20.6 deg C	59 %
1762506851	20.6 deg C	59.1 %
1762505950	20.6 deg C	59.1 %
1762504142	20.3 deg C	59.5 %
1762503247	20.1 deg C	60 %
1762502348	19.8 deg C	59.8 %
1762455582	21.5 deg C	56.6 %

*Used Equation Coefficients:

Temp: 0, 0.1, 0

Humi: 0, 0.1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)