FM1ZAB-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object FM1ZAB-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	T*
1755711438	14.14 Volt	2550 C
1755710236	14.14 Volt	2550 C
1755709035	14.14 Volt	2550 C
1755707834	14.14 Volt	2550 C
1755706633	14.14 Volt	2550 C
1755705432	14.14 Volt	2550 C
1755704231	14.54 Volt	2550 C
1755703029	14.54 Volt	2550 C
1755701828	14.54 Volt	2550 C
1755700627	14.54 Volt	2550 C
1755699426	14.54 Volt	2550 C
1755698225	14.46 Volt	2550 C
1755697023	14.46 Volt	2550 C
1755695822	14.14 Volt	2550 C
1755694621	13.83 Volt	2550 C
1755693420	13.51 Volt	2550 C
1755692219	13.83 Volt	2550 C
1755691018	13.51 Volt	2550 C
1755689816	13.11 Volt	2550 C
1755688615	12.96 Volt	2550 C
1755687414	12.88 Volt	2550 C
1755686213	12.8 Volt	2550 C
1755685012	12.72 Volt	2550 C
1755683810	12.72 Volt	2550 C
1755682609	12.72 Volt	2550 C

*Used Equation Coefficients:

Vin: 0, 0.079, 0

T: 0, 10, 0

V2: 0, 0, 0

A4: 0, 0, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)