SQ2WSZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2WSZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789968993	127 Count	317 Count	101 Count
1789968392	120 Count	304 Count	95 Count
1789967792	116 Count	295 Count	92 Count
1789967217	107 Count	283 Count	88 Count
1789966617	101 Count	273 Count	83 Count
1789966016	97 Count	265 Count	80 Count
1789965415	92 Count	253 Count	76 Count
1789964815	87 Count	246 Count	72 Count
1789964214	83 Count	238 Count	69 Count
1789963613	78 Count	225 Count	65 Count
1789963012	72 Count	200 Count	60 Count
1789962412	65 Count	158 Count	54 Count
1789961811	57 Count	113 Count	47 Count
1789961210	50 Count	96 Count	41 Count
1789960610	45 Count	86 Count	37 Count
1789960009	41 Count	76 Count	34 Count
1789959408	35 Count	65 Count	29 Count
1789958807	30 Count	56 Count	25 Count
1789958207	24 Count	44 Count	20 Count
1789957606	19 Count	35 Count	16 Count
1789957004	14 Count	27 Count	12 Count
1789956403	10 Count	19 Count	9 Count
1789955802	3 Count	7 Count	3 Count
1789955201	444 Count	1007 Count	349 Count
1789954600	440 Count	999 Count	346 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)