SQ4VW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4VW-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789963810	378 Count	678 Count	172 Count
1789963509	375 Count	674 Count	170 Count
1789963208	373 Count	671 Count	170 Count
1789962907	369 Count	668 Count	167 Count
1789962607	366 Count	662 Count	166 Count
1789962306	364 Count	660 Count	165 Count
1789962005	360 Count	653 Count	163 Count
1789961704	357 Count	647 Count	161 Count
1789961404	351 Count	629 Count	157 Count
1789961103	344 Count	597 Count	151 Count
1789960802	340 Count	584 Count	149 Count
1789960501	338 Count	582 Count	148 Count
1789960201	335 Count	575 Count	147 Count
1789959900	325 Count	557 Count	138 Count
1789959652	322 Count	556 Count	137 Count
1789959351	319 Count	548 Count	135 Count
1789959050	311 Count	533 Count	129 Count
1789958749	308 Count	528 Count	127 Count
1789958448	305 Count	525 Count	126 Count
1789958148	303 Count	520 Count	125 Count
1789957847	300 Count	518 Count	124 Count
1789957546	297 Count	512 Count	122 Count
1789957258	295 Count	510 Count	122 Count
1789956945	292 Count	508 Count	120 Count
1789956644	289 Count	505 Count	119 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)