OH6HL-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OH6HL-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	RF->INET*	DropRx*
1784500507	0 Pkts	1 Pkts
1784500266	1 Pkts	1 Pkts
1784499667	1 Pkts	2 Pkts
1784499066	0 Pkts	1 Pkts
1784498466	0 Pkts	1 Pkts
1784497832	1 Pkts	0 Pkts
1784497232	0 Pkts	1 Pkts
1784496619	0 Pkts	0 Pkts
1784496019	2 Pkts	3 Pkts
1784495419	2 Pkts	1 Pkts
1784494819	0 Pkts	0 Pkts
1784494583	2 Pkts	1 Pkts
1784493983	0 Pkts	1 Pkts
1784493349	3 Pkts	0 Pkts
1784492749	0 Pkts	1 Pkts
1784492113	2 Pkts	0 Pkts
1784491513	0 Pkts	1 Pkts
1784490877	3 Pkts	0 Pkts
1784490277	0 Pkts	0 Pkts
1784489643	3 Pkts	0 Pkts
1784489043	0 Pkts	1 Pkts
1784488450	2 Pkts	0 Pkts
1784487849	1 Pkts	1 Pkts
1784487213	2 Pkts	0 Pkts
1784486613	0 Pkts	1 Pkts

*Used Equation Coefficients:

RF->INET: 0, 1, 0

INET->RF: 0, 1, 0

DigiRpt: 0, 1, 0

TX2RF: 0, 1, 0

DropRx: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)