VK5KFB-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VK5KFB-15. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1753511492	511	614	999	762	636
1753510292	510	613	999	765	637
1753507890	511	606	999	756	638
1753490978	527	569	999	811	702
1753334220	541	621	999	741	620
1753333020	540	619	999	742	622
1753331818	536	617	999	759	633
1753329416	527	614	999	763	637
1753328216	525	610	999	767	641
1753327014	524	612	999	765	640
1753325814	524	610	999	768	641
1753324612	525	600	999	798	675
1753323031	524	612	999	763	637
1753320630	524	604	999	772	647
1753319430	508	600	999	776	653
1753318228	510	599	999	780	656
1753317028	513	585	999	810	696
1753316288	514	600	999	777	654
1753315086	514	594	999	785	666
1753153233	513	606	999	771	647
1753150832	521	611	999	766	641
1753148430	518	614	999	765	638
1753147230	520	610	999	768	643
1753146028	523	594	999	805	688
1753141893	521	600	999	780	655

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)