SQ2ODE-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2ODE-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1776678357	482 Count	261 Count
1776676556	481 Count	259 Count
1776674762	480 Count	257 Count
1776672962	479 Count	255 Count
1776671161	478 Count	253 Count
1776669360	477 Count	251 Count
1776667560	476 Count	250 Count
1776665759	475 Count	246 Count
1776663958	474 Count	243 Count
1776662158	473 Count	241 Count
1776660357	472 Count	239 Count
1776658557	471 Count	237 Count
1776656756	470 Count	235 Count
1776654955	469 Count	233 Count
1776653161	468 Count	231 Count
1776651361	467 Count	229 Count
1776649560	466 Count	227 Count
1776647760	465 Count	225 Count
1776645959	464 Count	223 Count
1776644158	463 Count	221 Count
1776642358	462 Count	219 Count
1776640557	461 Count	217 Count
1776638757	460 Count	215 Count
1776636956	459 Count	213 Count
1776635155	458 Count	211 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)