VE7SML-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object VE7SML-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Eff1h*
1776569118	11.33 Volt	100 Pcnt
1776568818	11.33 Volt	100 Pcnt
1776568518	11.33 Volt	100 Pcnt
1776568217	11.33 Volt	100 Pcnt
1776567917	11.33 Volt	100 Pcnt
1776567618	11.33 Volt	100 Pcnt
1776567016	11.4 Volt	100 Pcnt
1776566716	11.4 Volt	100 Pcnt
1776566416	11.4 Volt	100 Pcnt
1776566116	11.4 Volt	100 Pcnt
1776565815	11.4 Volt	100 Pcnt
1776565517	11.4 Volt	100 Pcnt
1776565217	11.4 Volt	100 Pcnt
1776564914	11.4 Volt	100 Pcnt
1776564614	11.48 Volt	100 Pcnt
1776564013	11.48 Volt	100 Pcnt
1776563413	11.48 Volt	100 Pcnt
1776563112	11.48 Volt	100 Pcnt
1776562812	11.48 Volt	100 Pcnt
1776562513	11.48 Volt	100 Pcnt
1776562212	11.48 Volt	100 Pcnt
1776561611	11.48 Volt	100 Pcnt
1776561311	11.48 Volt	100 Pcnt
1776561010	11.48 Volt	100 Pcnt
1776560710	11.55 Volt	100 Pcnt

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Rx1h: 0, 10, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

Temp: 0, 0.5, -64

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)