SP8KSR-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8KSR-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1785106699	534 Count	601 Count	534 Count
1785104898	499 Count	563 Count	499 Count
1785103098	480 Count	529 Count	480 Count
1785101298	455 Count	491 Count	455 Count
1785099498	435 Count	469 Count	435 Count
1785097698	421 Count	453 Count	421 Count
1785095898	396 Count	427 Count	396 Count
1785094098	366 Count	395 Count	366 Count
1785092298	336 Count	365 Count	336 Count
1785090498	306 Count	333 Count	306 Count
1785088698	290 Count	315 Count	290 Count
1785086911	268 Count	291 Count	268 Count
1785085111	247 Count	268 Count	247 Count
1785083311	226 Count	244 Count	226 Count
1785081511	206 Count	222 Count	206 Count
1785079711	185 Count	199 Count	185 Count
1785077911	160 Count	173 Count	160 Count
1785076111	122 Count	133 Count	122 Count
1785074311	108 Count	117 Count	108 Count
1785072511	92 Count	99 Count	92 Count
1785070710	67 Count	72 Count	67 Count
1785068910	35 Count	38 Count	35 Count
1785067110	1 Count	1 Count	1 Count
1785065306	914 Count	988 Count	914 Count
1785063505	893 Count	965 Count	893 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)