SP2GK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2GK-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1761510628	110 Count	14 Count
1761505218	107 Count	14 Count
1761503416	106 Count	14 Count
1761498014	103 Count	14 Count
1761496213	102 Count	14 Count
1761494412	101 Count	14 Count
1761492620	100 Count	14 Count
1761489018	98 Count	14 Count
1761487217	97 Count	14 Count
1761485417	96 Count	14 Count
1761483616	95 Count	14 Count
1761478213	92 Count	14 Count
1761476412	91 Count	14 Count
1761474616	90 Count	14 Count
1761469219	87 Count	14 Count
1761467417	86 Count	14 Count
1761463816	84 Count	14 Count
1761462014	83 Count	14 Count
1761460213	82 Count	14 Count
1761454811	79 Count	14 Count
1761445816	74 Count	14 Count
1761442214	72 Count	14 Count
1761435011	68 Count	14 Count
1761433210	67 Count	14 Count
1761429614	65 Count	14 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)