F4GMT-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4GMT-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1784688439	457 Count	984 Count
1784687539	456 Count	982 Count
1784686638	455 Count	979 Count
1784685737	454 Count	977 Count
1784684836	453 Count	974 Count
1784683936	452 Count	972 Count
1784683035	451 Count	969 Count
1784682135	450 Count	967 Count
1784681233	449 Count	964 Count
1784680333	448 Count	962 Count
1784679432	447 Count	959 Count
1784678531	446 Count	957 Count
1784677630	445 Count	954 Count
1784676730	444 Count	952 Count
1784675846	439 Count	949 Count
1784674945	438 Count	947 Count
1784674044	437 Count	944 Count
1784673143	436 Count	942 Count
1784672243	435 Count	939 Count
1784671341	434 Count	937 Count
1784670441	433 Count	934 Count
1784669540	432 Count	932 Count
1784668639	431 Count	929 Count
1784667738	430 Count	927 Count
1784666838	429 Count	924 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)