SM0PQB-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SM0PQB-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1772619360	88 Count	810 Count
1772617556	87 Count	799 Count
1772615753	86 Count	787 Count
1772613949	85 Count	775 Count
1772612146	84 Count	762 Count
1772610343	83 Count	752 Count
1772608540	82 Count	738 Count
1772599524	77 Count	680 Count
1772597755	72 Count	669 Count
1772595952	71 Count	657 Count
1772594149	70 Count	645 Count
1772592346	69 Count	633 Count
1772590543	68 Count	618 Count
1772588740	67 Count	607 Count
1772586937	66 Count	593 Count
1772585134	65 Count	582 Count
1772583331	64 Count	569 Count
1772581528	63 Count	558 Count
1772579725	62 Count	545 Count
1772577922	61 Count	534 Count
1772565338	50 Count	454 Count
1772563535	49 Count	443 Count
1772559929	47 Count	427 Count
1772558132	46 Count	413 Count
1772556322	45 Count	403 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)