LU5VQV-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object LU5VQV-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1788042187	55	42	29	21	120
1788041787	55	42	29	21	120
1788041387	55	42	29	22	120
1788040987	55	41	29	21	120
1788040587	55	42	29	21	120
1788040187	55	42	29	21	120
1788039787	55	42	29	21	120
1788039387	55	42	29	21	120
1788038988	55	41	29	21	120
1788038587	55	42	29	21	120
1788038187	55	42	29	21	120
1788037787	55	42	29	21	120
1788037387	55	41	29	21	120
1788036988	55	42	29	21	120
1788036587	55	42	29	21	120
1788036187	55	42	29	21	120
1788035787	55	41	29	21	120
1788035388	55	42	29	21	120
1788034987	55	42	29	21	120
1788034587	55	41	29	21	120
1788034187	55	42	29	21	120
1788033787	55	41	29	21	120
1788033387	54	41	29	21	120
1788032987	55	41	29	21	120
1788032587	55	42	29	21	120

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)