OE6ACM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OE6ACM-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp*	Pres*
1788693918	26 deg.C	935 mbar
1788693618	26 deg.C	935 mbar
1788693318	25.5 deg.C	935 mbar
1788693018	25.5 deg.C	935 mbar
1788692718	25 deg.C	935 mbar
1788692418	25 deg.C	935 mbar
1788692118	25 deg.C	935 mbar
1788691818	25 deg.C	935 mbar
1788691518	25 deg.C	935 mbar
1788691218	24.5 deg.C	935 mbar
1788690918	24.5 deg.C	935 mbar
1788690618	24.5 deg.C	935 mbar
1788690318	24.5 deg.C	935 mbar
1788690018	24.5 deg.C	935 mbar
1788689718	24.5 deg.C	935 mbar
1788689418	24.5 deg.C	935 mbar
1788689118	24.5 deg.C	935 mbar
1788688847	24.5 deg.C	935 mbar
1788688518	24.5 deg.C	935 mbar
1788688218	24 deg.C	936 mbar
1788687918	24 deg.C	936 mbar
1788687618	24 deg.C	936 mbar
1788687318	24 deg.C	936 mbar
1788687034	24 deg.C	936 mbar
1788686718	23.5 deg.C	936 mbar

*Used Equation Coefficients:

Temp: 0, 0.5, -40

Pres: 0, 1, 850

Humi: 0, 0.5, 0

xxx: 0, 1, 0

yyy: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)