IFRBST-6 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IFRBST-6. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Eff1h*
1785288235	12.23 Volt	100 Pcnt
1785284034	12.23 Volt	100 Pcnt
1785263633	12.23 Volt	100 Pcnt
1785261833	12.23 Volt	100 Pcnt
1785258834	12.23 Volt	100 Pcnt
1785254634	12.23 Volt	100 Pcnt
1785245636	12.23 Volt	100 Pcnt
1785243834	12.23 Volt	100 Pcnt
1785242634	12.23 Volt	100 Pcnt
1785242034	12.23 Volt	100 Pcnt
1785240234	12.23 Volt	100 Pcnt
1785239034	12.23 Volt	100 Pcnt
1785230034	12.23 Volt	100 Pcnt
1785228234	12.23 Volt	100 Pcnt
1785227634	12.23 Volt	100 Pcnt
1785219834	12.23 Volt	100 Pcnt
1785213835	12.23 Volt	100 Pcnt
1785213235	12.23 Volt	100 Pcnt
1785204235	12.23 Volt	100 Pcnt
1785203035	12.23 Volt	100 Pcnt
1785202435	12.23 Volt	100 Pcnt
1785200635	12.23 Volt	100 Pcnt
1785198836	12.23 Volt	100 Pcnt
1785197635	12.23 Volt	100 Pcnt
1785197035	12.23 Volt	100 Pcnt

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Rx1h: 0, 10, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)