OK1LOL-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1LOL-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1765784342	69 Count	292 Count
1765782539	68 Count	286 Count
1765780736	67 Count	280 Count
1765778932	66 Count	273 Count
1765777129	65 Count	266 Count
1765775326	64 Count	260 Count
1765773523	63 Count	254 Count
1765771756	62 Count	248 Count
1765769953	61 Count	242 Count
1765768152	60 Count	236 Count
1765766347	59 Count	230 Count
1765764544	58 Count	224 Count
1765762741	57 Count	218 Count
1765760938	56 Count	212 Count
1765759135	55 Count	206 Count
1765757332	54 Count	200 Count
1765755529	53 Count	194 Count
1765753726	52 Count	188 Count
1765751922	51 Count	180 Count
1765750155	50 Count	172 Count
1765748352	49 Count	165 Count
1765746549	48 Count	157 Count
1765744746	47 Count	150 Count
1765742943	46 Count	142 Count
1765741140	45 Count	134 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)