DG1RUE Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DG1RUE. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Battery*	Rx1h*
1776657570	13.29 Volt	13 Pkt
1776657270	13.29 Volt	13 Pkt
1776656969	13.29 Volt	13 Pkt
1776656669	13.29 Volt	13 Pkt
1776656369	13.29 Volt	13 Pkt
1776656068	13.29 Volt	13 Pkt
1776655768	13.29 Volt	13 Pkt
1776655468	13.29 Volt	13 Pkt
1776655167	13.29 Volt	13 Pkt
1776654867	13.29 Volt	13 Pkt
1776654567	13.29 Volt	13 Pkt
1776654267	13.29 Volt	13 Pkt
1776653966	13.29 Volt	13 Pkt
1776653666	13.29 Volt	13 Pkt
1776653366	13.29 Volt	13 Pkt
1776653065	13.29 Volt	13 Pkt
1776652765	13.29 Volt	13 Pkt
1776652465	13.29 Volt	13 Pkt
1776652165	13.29 Volt	13 Pkt
1776651864	13.29 Volt	13 Pkt
1776651564	13.29 Volt	13 Pkt
1776651264	13.29 Volt	12 Pkt
1776650963	13.29 Volt	11 Pkt
1776650663	13.29 Volt	10 Pkt
1776650363	13.29 Volt	10 Pkt

*Used Equation Coefficients:

Battery: 0, 0.078158, 0

Rx1h: 0, 1, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)