F4HUO-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4HUO-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773126578	391 Count	101 Count	25 Count
1773122977	389 Count	101 Count	25 Count
1773119375	387 Count	101 Count	25 Count
1773115774	385 Count	101 Count	25 Count
1773112173	383 Count	101 Count	25 Count
1773108571	381 Count	101 Count	25 Count
1773104977	379 Count	101 Count	25 Count
1773101375	377 Count	101 Count	25 Count
1773097777	375 Count	101 Count	25 Count
1773094173	373 Count	101 Count	25 Count
1773090571	371 Count	101 Count	25 Count
1773086970	369 Count	101 Count	25 Count
1773083378	367 Count	101 Count	25 Count
1773079776	365 Count	101 Count	25 Count
1773076174	363 Count	101 Count	25 Count
1773072573	361 Count	101 Count	25 Count
1773068971	359 Count	101 Count	25 Count
1773065370	357 Count	101 Count	25 Count
1773061777	355 Count	101 Count	25 Count
1773058176	353 Count	101 Count	25 Count
1773054574	351 Count	101 Count	25 Count
1773050973	349 Count	101 Count	25 Count
1773047371	347 Count	101 Count	25 Count
1773043769	345 Count	101 Count	25 Count
1773040175	343 Count	101 Count	25 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)