W3ADO-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W3ADO-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1787565595	47	143	78	50	217
1787559509	90	83	68	113	217
1787559449	110	85	84	105	217
1787559389	53	134	79	50	217
1787547000	48	122	70	51	217
1787546880	108	84	97	105	217
1787487448	85	90	69	121	217
1787481194	47	125	72	66	217
1787481134	157	158	30	211	217
1787468737	157	158	29	210	217
1787408985	47	124	77	59	217
1787402916	81	82	68	124	217
1787402496	158	159	31	211	217
1787396772	99	82	83	110	217
1787396592	78	83	68	115	217
1787390520	157	158	36	211	217
1787390464	45	137	68	67	217
1787390219	76	80	67	117	217
1787377940	78	84	82	94	217
1787311989	46	146	78	50	217
1787311874	69	74	66	109	217
1787227390	93	76	66	109	217
1787227330	100	79	76	106	217
1787221295	158	159	33	211	217
1787221235	106	79	85	97	217

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)