M0IGA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object M0IGA-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1789788248	917 Count	118 Count	111 Count
1789786748	916 Count	118 Count	111 Count
1789785247	915 Count	118 Count	111 Count
1789783746	914 Count	118 Count	111 Count
1789782246	913 Count	118 Count	111 Count
1789780745	912 Count	118 Count	111 Count
1789779244	911 Count	118 Count	111 Count
1789777744	910 Count	118 Count	111 Count
1789776243	909 Count	118 Count	111 Count
1789774742	908 Count	118 Count	111 Count
1789773242	907 Count	118 Count	111 Count
1789771741	906 Count	118 Count	111 Count
1789770240	905 Count	118 Count	111 Count
1789768739	904 Count	118 Count	111 Count
1789767239	903 Count	118 Count	111 Count
1789765738	902 Count	118 Count	111 Count
1789764237	901 Count	118 Count	111 Count
1789762737	900 Count	118 Count	111 Count
1789761236	899 Count	118 Count	111 Count
1789759735	898 Count	118 Count	111 Count
1789758235	897 Count	118 Count	111 Count
1789756734	896 Count	118 Count	111 Count
1789755233	895 Count	118 Count	111 Count
1789753733	894 Count	118 Count	111 Count
1789752232	893 Count	118 Count	111 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)