OK4RS-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK4RS-12. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1787582291	956 Count	111 Count	96 Count
1787580524	955 Count	111 Count	96 Count
1787578721	954 Count	111 Count	96 Count
1787576918	953 Count	111 Count	96 Count
1787575115	952 Count	111 Count	96 Count
1787573312	951 Count	111 Count	96 Count
1787571509	950 Count	111 Count	96 Count
1787569706	949 Count	111 Count	96 Count
1787567902	948 Count	111 Count	96 Count
1787566099	947 Count	111 Count	96 Count
1787564296	946 Count	111 Count	96 Count
1787562493	945 Count	111 Count	96 Count
1787560690	944 Count	111 Count	96 Count
1787558923	943 Count	111 Count	96 Count
1787557120	942 Count	111 Count	96 Count
1787555317	941 Count	111 Count	96 Count
1787553514	940 Count	111 Count	96 Count
1787551711	936 Count	108 Count	93 Count
1787549908	935 Count	108 Count	93 Count
1787548104	934 Count	108 Count	93 Count
1787546301	933 Count	108 Count	93 Count
1787544498	932 Count	108 Count	93 Count
1787542695	931 Count	108 Count	93 Count
1787540892	930 Count	108 Count	93 Count
1787539089	929 Count	108 Count	93 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)