TA1DRD-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object TA1DRD-15. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	RF->INET*	DropRx*
1788669528	1 Pkts	3 Pkts
1788668928	1 Pkts	3 Pkts
1788668328	0 Pkts	0 Pkts
1788567472	1 Pkts	3 Pkts
1788566871	2 Pkts	3 Pkts
1788566271	2 Pkts	3 Pkts
1788565676	1 Pkts	3 Pkts
1788565071	2 Pkts	3 Pkts
1788564471	1 Pkts	3 Pkts
1788563884	2 Pkts	3 Pkts
1788563271	1 Pkts	3 Pkts
1788562671	0 Pkts	3 Pkts
1788562071	1 Pkts	3 Pkts
1788561471	1 Pkts	3 Pkts
1788560871	0 Pkts	3 Pkts
1788560271	0 Pkts	3 Pkts
1788559671	1 Pkts	3 Pkts
1788559071	2 Pkts	3 Pkts
1788558471	0 Pkts	3 Pkts
1788557871	2 Pkts	3 Pkts
1788557271	1 Pkts	3 Pkts
1788556671	1 Pkts	3 Pkts
1788556071	1 Pkts	3 Pkts
1788555471	0 Pkts	3 Pkts
1788554871	3 Pkts	3 Pkts

*Used Equation Coefficients:

RF->INET: 0, 1, 0

INET->RF: 0, 1, 0

DigiRpt: 0, 1, 0

TX2RF: 0, 1, 0

DropRx: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)