ON3RIP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object ON3RIP-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1780557482	855 Count	177 Count
1780556579	844 Count	175 Count
1780555676	829 Count	174 Count
1780554772	818 Count	173 Count
1780553868	803 Count	171 Count
1780552965	790 Count	167 Count
1780552062	776 Count	166 Count
1780551159	765 Count	163 Count
1780550255	751 Count	157 Count
1780549352	741 Count	152 Count
1780548449	726 Count	152 Count
1780547545	712 Count	146 Count
1780546641	699 Count	146 Count
1780545738	688 Count	142 Count
1780544834	673 Count	140 Count
1780543931	661 Count	137 Count
1780543104	647 Count	136 Count
1780542201	636 Count	131 Count
1780541297	622 Count	128 Count
1780540394	608 Count	115 Count
1780539491	596 Count	97 Count
1780538588	585 Count	69 Count
1780537685	573 Count	68 Count
1780536781	560 Count	63 Count
1780535878	547 Count	62 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)