SQ9ITQ-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9ITQ-2. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1787570391	589 Count	125 Count	66 Count
1787568589	588 Count	125 Count	66 Count
1787566789	587 Count	125 Count	66 Count
1787564993	586 Count	125 Count	66 Count
1787563192	578 Count	118 Count	59 Count
1787561391	577 Count	118 Count	59 Count
1787559591	576 Count	118 Count	59 Count
1787557790	575 Count	118 Count	59 Count
1787555990	573 Count	117 Count	58 Count
1787554189	568 Count	113 Count	54 Count
1787552388	567 Count	113 Count	54 Count
1787550588	566 Count	113 Count	54 Count
1787548786	565 Count	113 Count	54 Count
1787546986	564 Count	113 Count	54 Count
1787545185	563 Count	113 Count	54 Count
1787543394	562 Count	113 Count	54 Count
1787541593	561 Count	113 Count	54 Count
1787539793	560 Count	113 Count	54 Count
1787537992	559 Count	113 Count	54 Count
1787536192	558 Count	113 Count	54 Count
1787534391	557 Count	113 Count	54 Count
1787532590	556 Count	113 Count	54 Count
1787530790	555 Count	113 Count	54 Count
1787528989	554 Count	113 Count	54 Count
1787527220	553 Count	113 Count	54 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)