SR7QDX Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR7QDX. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	Vin*	Eff1h*
1777654446	12.23 Volt	100 Pcnt
1777650846	12.23 Volt	100 Pcnt
1777647246	12.23 Volt	100 Pcnt
1777643646	12.23 Volt	100 Pcnt
1777640046	12.23 Volt	100 Pcnt
1777636446	12.23 Volt	100 Pcnt
1777632846	12.23 Volt	100 Pcnt
1777629246	12.23 Volt	100 Pcnt
1777625646	12.23 Volt	100 Pcnt
1777622046	12.23 Volt	100 Pcnt
1777618446	12.23 Volt	100 Pcnt
1777614846	12.23 Volt	100 Pcnt
1777611247	12.23 Volt	100 Pcnt
1777607647	12.23 Volt	100 Pcnt
1777604047	12.23 Volt	100 Pcnt
1777600447	12.23 Volt	100 Pcnt
1777596847	12.23 Volt	100 Pcnt
1777593247	12.23 Volt	100 Pcnt
1777589647	12.23 Volt	100 Pcnt
1777586047	12.23 Volt	100 Pcnt
1777582447	12.23 Volt	100 Pcnt
1777578847	12.23 Volt	100 Pcnt
1777575247	12.23 Volt	100 Pcnt
1777571647	12.23 Volt	100 Pcnt

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Rx1h: 0, 10, 0

Dg1h: 0, 10, 0

Eff1h: 0, 1, 0

A5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)