IR6BC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IR6BC-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Vin*	Eff1h*
1780536045	12.75 Volt	100 Pcnt
1780535745	12.75 Volt	100 Pcnt
1780535445	12.75 Volt	100 Pcnt
1780535145	12.75 Volt	100 Pcnt
1780534845	12.75 Volt	100 Pcnt
1780534545	12.75 Volt	100 Pcnt
1780534245	12.75 Volt	100 Pcnt
1780533945	12.75 Volt	100 Pcnt
1780533645	12.75 Volt	100 Pcnt
1780533345	12.75 Volt	100 Pcnt
1780533045	12.68 Volt	100 Pcnt
1780532745	12.75 Volt	100 Pcnt
1780532445	12.75 Volt	100 Pcnt
1780532145	12.75 Volt	100 Pcnt
1780531845	12.75 Volt	100 Pcnt
1780531545	12.75 Volt	100 Pcnt
1780531245	12.75 Volt	100 Pcnt
1780530945	12.75 Volt	100 Pcnt
1780530645	12.75 Volt	100 Pcnt
1780530345	12.75 Volt	100 Pcnt
1780530045	12.75 Volt	100 Pcnt
1780529745	12.75 Volt	100 Pcnt
1780529445	12.75 Volt	100 Pcnt
1780529146	12.75 Volt	100 Pcnt
1780528845	12.75 Volt	100 Pcnt

*Used Equation Coefficients:

Vin: 0, 0.075, 0

Rx10m: 0, 1, 0

Dg10m: 0, 1, 0

Eff1h: 0, 1, 0

Dg/Rx: 0, 0.001, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)