2M0SBP-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 2M0SBP-15. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1757500671	53 Count	863 Count
1757498867	52 Count	848 Count
1757497099	51 Count	835 Count
1757495296	50 Count	821 Count
1757493493	49 Count	808 Count
1757491690	48 Count	795 Count
1757489887	47 Count	781 Count
1757488083	46 Count	766 Count
1757486280	45 Count	751 Count
1757484477	44 Count	739 Count
1757482674	43 Count	724 Count
1757480871	42 Count	709 Count
1757479068	41 Count	694 Count
1757477265	40 Count	676 Count
1757475499	39 Count	661 Count
1757473696	38 Count	650 Count
1757471892	37 Count	635 Count
1757470089	36 Count	620 Count
1757468286	35 Count	605 Count
1757466483	34 Count	590 Count
1757464680	33 Count	575 Count
1757462877	32 Count	562 Count
1757461074	31 Count	547 Count
1757459271	30 Count	532 Count
1757457467	29 Count	517 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)