MB7UKB-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object MB7UKB-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	CPU*	Used*
1780884092	42.93 C	232 MB
1780882292	42.93 C	228 MB
1780880492	42.93 C	232 MB
1780878692	42.93 C	229 MB
1780876892	42.93 C	228 MB
1780875092	42.93 C	232 MB
1780873292	42.93 C	232 MB
1780871492	42.93 C	228 MB
1780869692	42.39 C	233 MB
1780867892	42.39 C	231 MB
1780866092	42.93 C	235 MB
1780864292	42.39 C	235 MB
1780862492	42.93 C	230 MB
1780860692	42.93 C	231 MB
1780858892	42.93 C	249 MB
1780857092	42.93 C	250 MB
1780855292	42.93 C	320 MB
1780853491	42.93 C	272 MB
1780851691	41.85 C	271 MB
1780849891	42.93 C	273 MB
1780848092	42.93 C	272 MB
1780846291	42.93 C	271 MB
1780844491	42.93 C	269 MB
1780842691	42.93 C	271 MB
1780840891	42.93 C	268 MB

*Used Equation Coefficients:

CPU: 0, 0.01, 0

Used: 0, 1, 0

Value3: 0, 0, 0

Value4: 0, 0, 0

Value5: 0, 0, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)