SP3ME Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3ME. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1773044983	125 Count	811 Count	57 Count
1773044683	124 Count	781 Count	57 Count
1773043781	117 Count	722 Count	53 Count
1773043480	116 Count	705 Count	53 Count
1773043179	114 Count	687 Count	52 Count
1773042878	113 Count	666 Count	52 Count
1773042578	111 Count	641 Count	51 Count
1773042278	108 Count	620 Count	49 Count
1773041976	107 Count	596 Count	49 Count
1773041676	105 Count	584 Count	48 Count
1773041074	103 Count	555 Count	48 Count
1773040773	102 Count	532 Count	48 Count
1773040473	99 Count	511 Count	46 Count
1773039871	96 Count	461 Count	45 Count
1773039571	93 Count	433 Count	43 Count
1773039270	92 Count	407 Count	43 Count
1773038969	91 Count	385 Count	43 Count
1773038669	89 Count	364 Count	42 Count
1773038368	88 Count	345 Count	42 Count
1773038067	87 Count	321 Count	42 Count
1773037766	84 Count	297 Count	40 Count
1773037466	82 Count	271 Count	39 Count
1773037165	80 Count	254 Count	38 Count
1773036864	77 Count	247 Count	36 Count
1773036564	76 Count	238 Count	36 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)