EB5BZM-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB5BZM-11. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1761502975	259 Count	638 Count
1761502761	258 Count	638 Count
1761502743	257 Count	638 Count
1761237012	122 Count	567 Count
1761234035	120 Count	567 Count
1761231932	118 Count	567 Count
1761229828	117 Count	567 Count
1761227725	116 Count	567 Count
1761223518	114 Count	567 Count
1761221415	113 Count	567 Count
1761219311	112 Count	567 Count
1761217208	111 Count	567 Count
1761215105	110 Count	567 Count
1761213001	109 Count	567 Count
1761212837	108 Count	567 Count
1761210734	107 Count	567 Count
1761208630	106 Count	567 Count
1761206526	103 Count	567 Count
1761204423	102 Count	529 Count
1761202320	101 Count	514 Count
1761200216	100 Count	514 Count
1761198113	98 Count	493 Count
1761196010	97 Count	493 Count
1761193906	96 Count	493 Count
1761191803	94 Count	493 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)