W3GV-5 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object W3GV-5. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1787485509	178	29	27	23	43
1787484611	178	29	27	24	44
1787454909	178	29	27	23	43
1787427010	178	29	27	24	43
1787387410	178	29	27	24	43
1787382909	178	29	27	23	43
1787378409	178	29	27	24	43
1787373909	178	29	27	23	43
1787372108	178	29	27	23	43
1787371208	178	29	27	24	43
1787370308	178	29	27	23	43
1787369408	178	29	27	24	43
1787366709	178	29	27	23	43
1787364909	178	29	27	23	43
1787364010	178	29	27	24	43
1787362210	178	29	27	24	44
1787360409	178	29	27	24	44
1787350508	178	29	27	23	44
1787320809	178	29	27	24	43
1787319908	178	29	27	23	43
1787319009	178	29	27	24	43
1787316308	178	29	27	23	43
1787314508	178	29	27	23	43
1787313609	178	29	27	24	43
1787310908	178	29	27	23	43

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)