WB6ETY-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object WB6ETY-3. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Value1*	Value2*	Value3*	Value4*	Value5*
1784678070	1375	961	462	959	41
1784677389	1374	958	462	959	40
1784677349	1374	958	456	959	42
1784676630	1374	958	456	959	41
1784675909	1374	957	456	954	41
1784675589	1374	957	462	954	39
1784675190	1374	956	456	954	42
1784674470	1375	953	456	950	39
1784673789	1374	950	451	950	38
1784673751	1374	950	456	950	38
1784673030	1374	947	451	946	37
1784672310	1374	944	451	941	38
1784672010	1374	942	451	941	39
1784671590	1375	941	451	941	40
1784670870	1374	938	451	932	39
1784670189	1377	934	445	932	38
1784670150	1374	933	445	932	39
1784669430	1374	930	445	928	41
1784668710	1374	928	440	923	39
1784668389	1374	925	440	923	37
1784667991	1375	923	440	923	40
1784667270	1374	920	445	918	38
1784666589	1378	916	440	914	38
1784666549	1374	916	429	914	39
1784665830	1374	912	440	910	39

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)