SP8NCG-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8NCG-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1788648576	695 Count	479 Count
1788646775	689 Count	476 Count
1788644975	683 Count	473 Count
1788643174	677 Count	470 Count
1788641373	671 Count	467 Count
1788639572	665 Count	464 Count
1788637771	659 Count	461 Count
1788635971	653 Count	458 Count
1788634170	647 Count	455 Count
1788632369	641 Count	452 Count
1788630568	640 Count	449 Count
1788607175	567 Count	410 Count
1788605374	561 Count	407 Count
1788603573	555 Count	404 Count
1788601772	549 Count	401 Count
1788599971	543 Count	398 Count
1788598171	537 Count	395 Count
1788596370	531 Count	392 Count
1788594569	525 Count	389 Count
1788592768	519 Count	386 Count
1788590968	513 Count	383 Count
1788589167	507 Count	380 Count
1788587366	505 Count	377 Count
1788585581	499 Count	374 Count
1788583773	493 Count	371 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)