SP9GWP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9GWP-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1784640159	51 Count	1 Count
1784638358	50 Count	1 Count
1784636559	49 Count	1 Count
1784629361	45 Count	1 Count
1784627561	44 Count	1 Count
1784625760	43 Count	1 Count
1784623959	42 Count	1 Count
1784622159	41 Count	1 Count
1784620358	40 Count	1 Count
1784618557	39 Count	1 Count
1784616757	38 Count	1 Count
1784614956	37 Count	1 Count
1784613155	36 Count	1 Count
1784611364	35 Count	1 Count
1784609554	34 Count	1 Count
1784607763	33 Count	1 Count
1784605962	32 Count	1 Count
1784604172	31 Count	1 Count
1784602361	30 Count	1 Count
1784600560	29 Count	1 Count
1784598759	28 Count	1 Count
1784596959	27 Count	1 Count
1784595158	26 Count	1 Count
1784593357	25 Count	1 Count
1784591557	24 Count	1 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)