F5MIW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F5MIW-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1784688416	508 Count	868 Count	383 Count
1784687512	504 Count	862 Count	380 Count
1784686722	501 Count	859 Count	378 Count
1784685817	497 Count	854 Count	375 Count
1784684913	493 Count	850 Count	372 Count
1784684009	489 Count	845 Count	369 Count
1784683105	485 Count	840 Count	366 Count
1784682200	482 Count	836 Count	364 Count
1784681296	478 Count	831 Count	361 Count
1784680388	473 Count	825 Count	357 Count
1784679484	469 Count	819 Count	354 Count
1784678579	465 Count	813 Count	351 Count
1784677675	462 Count	808 Count	349 Count
1784676771	458 Count	803 Count	346 Count
1784675867	454 Count	797 Count	343 Count
1784674963	450 Count	792 Count	340 Count
1784674058	447 Count	787 Count	338 Count
1784673156	442 Count	782 Count	334 Count
1784672250	438 Count	777 Count	331 Count
1784671345	435 Count	772 Count	329 Count
1784670441	431 Count	767 Count	326 Count
1784669537	427 Count	762 Count	323 Count
1784668632	423 Count	757 Count	320 Count
1784667728	419 Count	752 Count	317 Count
1784666824	416 Count	749 Count	315 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)