EA8EE-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA8EE-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1753662718	159 Count	120 Count	120 Count
1753660915	155 Count	117 Count	117 Count
1753659112	151 Count	114 Count	114 Count
1753657309	147 Count	111 Count	111 Count
1753655506	143 Count	108 Count	108 Count
1753653703	139 Count	105 Count	105 Count
1753651900	135 Count	102 Count	102 Count
1753650097	131 Count	99 Count	99 Count
1753626730	79 Count	60 Count	60 Count
1753624927	75 Count	57 Count	57 Count
1753623124	71 Count	54 Count	54 Count
1753619517	63 Count	48 Count	48 Count
1753617714	59 Count	45 Count	45 Count
1753615910	55 Count	42 Count	42 Count
1753612304	47 Count	36 Count	36 Count
1753610501	43 Count	33 Count	33 Count
1753608698	39 Count	30 Count	30 Count
1753606895	35 Count	27 Count	27 Count
1753605128	31 Count	24 Count	24 Count
1753603325	27 Count	21 Count	21 Count
1753601522	23 Count	18 Count	18 Count
1753599719	19 Count	15 Count	15 Count
1753597916	15 Count	12 Count	12 Count
1753596113	11 Count	9 Count	9 Count
1753594310	7 Count	6 Count	6 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)