DK8AF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object DK8AF-10. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	Temp*	Humi*
1780575092	26.9 deg C	42.6 %
1780574192	27.7 deg C	41.4 %
1780573291	27.9 deg C	41.1 %
1780572391	27.9 deg C	41.2 %
1780571491	27.9 deg C	41.2 %
1780570591	28 deg C	41 %
1780569691	28.1 deg C	40.6 %
1780569359	28.2 deg C	40.4 %
1780568459	28.5 deg C	40 %
1780567559	29.3 deg C	38.7 %
1780566659	28.4 deg C	40.9 %
1780565758	28.3 deg C	40.9 %
1780564858	28.2 deg C	41.2 %
1780563958	28.2 deg C	41.6 %
1780563058	28.3 deg C	41.2 %
1780562158	28.3 deg C	41 %
1780561258	28.2 deg C	41 %
1780560358	28.2 deg C	41.1 %
1780559458	28.2 deg C	41.1 %
1780558558	28.2 deg C	41 %
1780557658	28.2 deg C	41 %
1780557444	28.2 deg C	41.1 %
1780556544	28.3 deg C	41.1 %
1780555644	28.3 deg C	40.4 %
1780554744	28.3 deg C	40 %

*Used Equation Coefficients:

Temp: 0, 0.1, 0

Humi: 0, 0.1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)