SP4SR-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP4SR-1. If no packets are shown the sender has not sent any telemetry packets the latest 10 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1765510069	770 Count	362 Count
1765508269	769 Count	362 Count
1765506469	768 Count	361 Count
1765504667	767 Count	360 Count
1765502867	766 Count	359 Count
1765499266	764 Count	359 Count
1765497471	759 Count	357 Count
1765495672	758 Count	357 Count
1765493871	757 Count	357 Count
1765492070	756 Count	357 Count
1765484867	752 Count	357 Count
1765483068	751 Count	357 Count
1765481266	750 Count	357 Count
1765479467	749 Count	357 Count
1765475871	743 Count	356 Count
1765474070	742 Count	355 Count
1765472270	741 Count	355 Count
1765470470	740 Count	355 Count
1765456065	732 Count	355 Count
1765454270	727 Count	355 Count
1765452469	726 Count	355 Count
1765448869	724 Count	355 Count
1765447067	723 Count	355 Count
1765443467	721 Count	355 Count
1765441666	720 Count	355 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)